Home › BODY ELECTRICAL › LIGHTING › HEADLIGHT LEVELING SWITCH

HEADLIGHT LEVELING SWITCH > INSPECTION

for Preparation Click here



1. INSPECT HEADLIGHT LEVELING SWITCH


B113718E03
  1. Inspect the headlight leveling switch operation.

    1. Apply battery voltage to the headlight leveling switch connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard voltage:
      Measurement Condition
      Switch Condition
      Tester Connection
      Specified Condition
      (Battery voltage is 12 V)
      Battery positive (+) → 1 (B)
      Battery negative (-) → 2 (E)
      0
      4 (LH+) - 2 (E)
      5 (RH+) - 2 (E)
      10.44 to 11.16 V
      Battery positive (+) → 1 (B)
      Battery negative (-) → 2 (E)
      1
      4 (LH+) - 2 (E)
      5 (RH+) - 2 (E)
      8.52 to 9.24 V
      Battery positive (+) → 1 (B)
      Battery negative (-) → 2 (E)
      2
      4 (LH+) - 2 (E)
      5 (RH+) - 2 (E)
      6.60 to 7.32 V
      Battery positive (+) → 1 (B)
      Battery negative (-) → 2 (E)
      3
      4 (LH+) - 2 (E)
      5 (RH+) - 2 (E)
      4.68 to 5.4 V
      Battery positive (+) → 1 (B)
      Battery negative (-) → 2 (E)
      4
      4 (LH+) - 2 (E)
      5 (RH+) - 2 (E)
      2.76 to 3.48 V
      Battery positive (+) → 1 (B)
      Battery negative (-) → 2 (E)
      5
      4 (LH+) - 2 (E)
      5 (RH+) - 2 (E)
      0.84 to 1.56 V

      If the result is not as specified, replace the headlight leveling switch.

  1. Inspect illumination operation.

    1. Apply battery voltage to the headlight leveling switch connector.

    2. Check that the illumination comes on.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → 3
      Battery negative (-) → 6
      Illumination comes on

      If the result is not as specified, replace the headlight leveling switch.



    E066582E01
  1. Inspect operation of the headlight leveling light.

    1. Connect the battery's positive (+) lead to terminal 3 and negative (-) lead to terminal 6, then check that the LED illuminates.

      OK:
      LED illuminates.

      If the result is not as specified, replace the headlight leveling switch assembly.