AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System) > PTC Heater Circuit |

| 1.INSPECT PTC HEATER RELAY (NO. 1, NO. 2) |
![]() |
Remove the No. 1 PTC heater relay and No. 2 PTC heater relay.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3 - 5 | Battery voltage is not applied between terminals 1 and 2 | 10 kΩ or higher |
| Battery voltage is applied between terminals 1 and 2 | Below 1 Ω |
|
| ||||
| OK | |
| 2.CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY |
![]() |
Remove the air conditioning amplifier with its connectors still connected.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A36-1 (PTC1) - Body ground | Ignition switch ON Generator is operating Temperature switch Max. HOT Coolant temperature: Below 65°C (149°F) Ambient temperature: Below 10°C (50°F) Power heater switch ON Blower switch ON (LO) | 11 to 14 V |
| A36-2 (PTC2) - Body ground |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (PTC HEATER RELAY - PTC HEATER) |
![]() |
Remove the No. 1 PTC heater relay and No. 2 PTC heater relay.
Disconnect the P17 heater connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| P18-5 - P17-2 (B) | Always | Below 1 Ω |
| P19-5 - P17-1 (B) |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (PTC HEATER - BODY GROUND) |
![]() |
Disconnect the P16 heater connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| P16-1 (E) - Body ground | Always | Below 1 Ω |
| P16-2 (E) - Body ground |
|
| ||||
| OK | |
| 5.CHECK PTC HEATER |
![]() |
Disconnect the P17 and P16 PTC heater connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| P17-1 (B) - P16-1 (E) | Always | Below 1 Ω |
| P17-2 (B) - P16-2 (E) |
|
| ||||
| OK | |
| 6.CHECK HARNESS AND CONNECTOR (PTC HEATER RELAY - AMPLIFIER AND BODY GROUND) |
![]() |
Remove the No. 1 PTC heater relay and No. 2 PTC heater relay.
Disconnect the A36 amplifier connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| P18-2 - A36-1 (PTC1) | Always | Below 1 Ω |
| P19-2 - A36-2 (PTC2) | ||
| P18-1 - Body ground | Always | Below 1 Ω |
| P19-1 - Body ground |
|
| ||||
| OK | ||
| ||