Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)

AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System) > Power Heater Switch Circuit

for Preparation Click here


DESCRIPTION

The power heater operates when the power heater switch is on and the following conditions are met:
  1. Ignition switch is ON.
  2. Air inlet control damper position is FRESH.
  3. Blower motor switch is in any position other than OFF.
  4. Air mix damper position is Max. HOT.
  5. Engine coolant temperature is below 65°C (149°F).

WIRING DIAGRAM


E170986E01


INSPECTION PROCEDURE

1.INSPECT POWER HEATER SWITCH


    E171024E01
  1. Remove the power heater switch.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    4 - 1
    Power heater switch ON
    Below 1 Ω
    4 - 1
    Power heater switch OFF
    10 kΩ or higher

  1. Apply battery voltage to the switch connector and check that the indicator light illuminates.

    OK:
    Measurement Connection
    Specified Condition
    Battery positive (+) → Terminal 5
    Indicator light illuminates
    Battery negative (-) → Terminal 8



NG
REPLACE POWER HEATER SWITCH
OK


2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - BODY GROUND)


    E170988E03
  1. Remove the air conditioning amplifier with its connectors still connected.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    A36-8 (HEAT) - Body ground
    Ignition switch ON
    Power heater switch ON
    Below 1 V
    Ignition switch ON
    Power heater switch OFF
    11 to 14 V
    A36-5 (SWIN) - Body ground
    Ignition switch ON
    Power heater switch ON
    Below 1 V
    Ignition switch ON
    Power heater switch OFF
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)