Home › BODY ELECTRICAL › LIGHTING › FOG LIGHT ASSEMBLY

FOG LIGHT ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL FOG LIGHT ASSEMBLY RH WITH BRACKET


B087792
  1. Install the fog light and fog cover with the 2 bolts.

  1. Connect the connectors.



2. INSTALL FOG LIGHT ASSEMBLY LH WITH BRACKET


B085698
  1. Install the fog light and fog cover with the 2 bolts.

  1. Connect the connectors.



3. INSTALL FRONT BUMPER COVER
  1. w/ Fog light:
    Connect the 2 fog light connectors.



    B085206E01
  1. Put protective tape under the front fender.

  1. Attach the 4 claws to install the cover.



    B085205E01
  1. Install the 9 clips.



4. INSTALL ENGINE SIDE COVER SUB-ASSEMBLY LH (for 4WD)


B085200E01
  1. Attach the 2 claws to install the retainer.

  1. Install the screw.



5. INSTALL ENGINE SIDE COVER SUB-ASSEMBLY RH (for 4WD)

HINT:
Use the same procedures described for the LH side.



6. INSTALL FRONT FENDER LINER LH


B085207E01
  1. Install the fender liner with the 3 clips and screw.



7. INSTALL RADIATOR GRILLE


B108604E01
  1. Push the radiator grille in the direction indicated by the arrow in the illustration. Attach the 5 claws to install the radiator grille.

  1. Install the 2 screws and 2 clips.



8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


9. PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal