Home › BODY ELECTRICAL › LIGHTING › PERSONAL LIGHT ASSEMBLY

PERSONAL LIGHT ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL MAP LIGHT ASSEMBLY


B117646
  1. Install the bulb to the light.

  1. Connect the connector.

  1. Attach the map light as shown in the illustration.

  1. Install the 2 screws.



2. INSTALL NO. 1 MAP LIGHT LENS


B123982
  1. Attach the 2 claws to install the No. 1 light lens.



3. INSTALL NO. 2 MAP LIGHT LENS

HINT:
Use the same procedures described for the No. 1 lens.



4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


5. PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.