Home › BODY ELECTRICAL › LIGHTING › FOG LIGHT ASSEMBLY

FOG LIGHT ASSEMBLY > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE RADIATOR GRILLE


B085203E01
  1. Using a clip remover, remove the 2 clips.

  1. Remove the 2 screws.

  1. Pull the radiator grille in the direction indicated by the arrow in the illustration to detach the 5 claws and remove the radiator grille.



3. REMOVE FRONT FENDER LINER LH


B085207E01
  1. Remove the screw.

  1. Using a clip remover, remove the 3 clips.

  1. Partially remove the fender liner.

    HINT:
    It is not necessary to fully remove the fender liner. Partially remove it so that the bumper cover can be removed in a later step.



4. REMOVE ENGINE SIDE COVER SUB-ASSEMBLY LH (for 4WD)


B112763E02
  1. Using a clip remover, remove the 2 clips.

  1. Remove the 3 bolts and engine side cover.



5. REMOVE ENGINE SIDE COVER SUB-ASSEMBLY RH (for 4WD)

HINT:
Use the same procedures described for the LH side.



6. REMOVE FRONT BUMPER COVER


B085205E01
  1. Using a clip remover, remove the 9 clips.



    B085206E01
  1. Put protective tape under the front fender.

  1. Detach the 4 claws and remove the bumper cover.

  1. w/ Fog light:
    Disconnect the 2 fog light connectors.



7. REMOVE FOG LIGHT ASSEMBLY LH WITH BRACKET


B123690
  1. Disconnect the connectors.

  1. Remove the 2 bolts, fog light and fog cover.



8. REMOVE FOG LIGHT ASSEMBLY RH WITH BRACKET


B123693
  1. Disconnect the connectors.

  1. Remove the 2 bolts, fog light and fog cover.