Home › BODY ELECTRICAL › LIGHTING › PERSONAL LIGHT ASSEMBLY

PERSONAL LIGHT ASSEMBLY > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE NO. 1 MAP LIGHT LENS


B117647
  1. Using a screwdriver, pry out the light lens.

    HINT:
    Tape the screwdriver tip before use.



3. REMOVE NO. 2 MAP LIGHT LENS

HINT:
Use the same procedures described for the No. 1 lens.



4. REMOVE MAP LIGHT ASSEMBLY


B117648
  1. Remove the 2 screws.

  1. Pull the map light toward the vehicle's front, and remove the map light as shown in the illustration.

  1. Disconnect the light connector.

  1. Remove the bulb from the light.