Home › BODY › SEAT › SEAT HEATER SWITCH

SEAT HEATER SWITCH > INSPECTION

for Preparation Click here



1. INSPECT SEAT HEATER SWITCH LH


    B059759E01
  1. Measure the resistance of the seat heater switch when the switch is operated.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    3 (IG) - 4 (LH)
    ON
    Below 1 Ω
    3 (IG) - 4 (LH)
    OFF
    10 kΩ or high

    If the result is not as specified, replace the switch.

  1. Check that the seat heater switch indicator light illuminates when the switch is operated.

    OK:
    Tester Connection
    Switch Condition
    Specified Condition
    Battery positive (+) → 3 (IG)
    Battery negative (-) → 6 (E)
    ON
    Illuminates

    If the result is not as specified, replace the switch or bulb.

  1. Check that the seat heater switch illuminates.

    OK:
    Tester Connection
    Switch Condition
    Specified Condition
    Battery positive (+) → 1 (ILL+)
    Battery negative (-) → 2 (ILL-)
    Always
    Illuminates

    If the result is not as specified, replace the switch or bulb.



2. INSPECT SEAT HEATER SWITCH RH


    B059760E01
  1. Measure the resistance of the seat heater switch when the switch is operated.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    3 (IG) - 4 (RH)
    ON
    Below 1 Ω
    3 (IG) - 4 (RH)
    OFF
    10 kΩ or high

    If the result is not as specified, replace the switch.

  1. Check that the seat heater switch indicator light illuminates when the switch is operated.

    OK:
    Tester Connection
    Switch Condition
    Specified Condition
    Battery positive (+) → 3 (IG)
    Battery negative (-) → 6 (E)
    ON
    Illuminates

    If the result is not as specified, replace the switch or bulb.

  1. Check that the seat heater switch illuminates.

    OK:
    Tester Connection
    Switch Condition
    Specified Condition
    Battery positive (+) → 1 (ILL+)
    Battery negative (-) → 2 (ILL-)
    Always
    Illuminates

    If the result is not as specified, replace the switch or bulb.