Home › ENGINE · 5L-E › ENGINE CONTROL SYSTEM › ECD SYSTEM

DTC    13 (2)    Engine Speed Sensor Circuit Malfunction

for Preparation Click here


DESCRIPTION

The engine speed sensor in the Engine Control System contains a signal plate and a pickup coil for NE signal. The NE signal plate has 56 teeth and is mounted in the injection pump. The NE signal sensor generates 56 signals for every 2 engine revolutions. The ECM detects the engine speed and cam lift position of the injection pump. The ECM uses TDC signals and NE signals for injection timing control. NE signals are also used for injection volume control.

DTC No.
DTC Detection Condition
Trouble Area
13 (2)
No NE signal to ECM for 0.5 sec. or more at 680 rpm or more
  1. Open or short in engine speed sensor circuit
  2. Engine speed sensor
  3. ECM
No NE signal to ECM for 2.0 sec. or more during cranking

WIRING DIAGRAM


A119265E01


INSPECTION PROCEDURE

1.INSPECT ENGINE SPEED SENSOR


    A105092E02
  1. Check the engine speed sensor installation.

  1. Disconnect the engine speed sensor connector.

  1. Measure the resistance of the engine speed sensor.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 (NE-) - 2 (NE+)
    20°C (68°F)
    205 to 255 Ω

    HINT:
    The engine speed sensor is integrated with the injection pump assembly. If the engine speed sensor needs to be replaced, the entire injection pump assembly must be replaced.



NG
CHECK AND REPLACE INJECTION PUMP ASSEMBLY
OK


2.CHECK ECM (TDC, NE SIGNAL)


    A106823E05
  1. While cranking or idling, measure the waveform according to the value(s) in the table below.

    OK:
    Tester Connection
    Specified Condition
    E23-19 (NE+) - E23-18 (NE-)
    Correct waveform is as shown
    E23-17 (TDC+) - E23-16 (TDC-)
    Correct waveform is as shown



OK
REPLACE ECM
NG


3.CHECK WIRE HARNESS (ECM - ENGINE SPEED SENSOR)


    A106825E03
  1. Disconnect the engine speed sensor connector.

  1. Disconnect the E23 ECM connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    E19-2 (NE+) - E23-19 (NE+)
    Below 1 Ω
    E19-1 (NE-) - E23-18 (NE-)
    Below 1 Ω
    E23-19 (NE+) - E23-18 (NE-)
    10 kΩ or higher
    E23-19 (NE+) - Body ground
    10 kΩ or higher
    E23-18 (NE-) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

CHECK FOR INTERMITTENT PROBLEMS