DTC 18 (5) Spill Control Circuit Malfunction |

| DTC No. | DTC Detection Condition | Trouble Area |
| 18 (5) | Open or short in spill control valve at 500 rpm or more |
|

| 1.INSPECT SPILL CONTROL VALVE |
![]() |
Disconnect the spill control valve connector.
Measure the resistance of the spill control valve.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | 20°C (68°F) | 1 to 2 Ω |
|
| ||||
| OK | |
| 2.CHECK ECM (SPV+ VOLTAGE) |
![]() |
Disconnect the S26 spill control valve connector.
Turn the ignition switch ON.
Measure the voltage of the ECM connector.
| Tester Connection | Specified Condition |
| E23-12 (SPV+) - E23-14 (E1) | 9 to 14 V |
|
| ||||
| OK | |
| 3.CHECK ECM (SPV- VOLTAGE) |
![]() |
Turn the ignition switch ON.
Measure the voltage of the ECM connector.
| Tester Connection | Specified Condition |
| E23-25 (SPV-) - E23-14 (E1) | 9 to 14 V |
While idling, measure the waveform with an oscilloscope connected between the specified terminals of ECM connector.
| Tester Connection | Specified Condition |
| SPV- (E23-25) - E1 (E23-14) | Correct waveform is as shown |
|
| ||||
| NG | |
| 4.CHECK WIRE HARNESS (ECM - SPILL CONTROL VALVE) |
![]() |
Disconnect the S26 spill control valve connector.
Disconnect the E23 ECM connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| S26-2 - E23-12 (SPV+) | Below 1 Ω |
| S26-1 - E23-25 (SPV-) | Below 1 Ω |
| E23-12 (SPV+) - Body ground | 10 kΩ or higher |
| E23-25 (SPV-) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||