DTC 39 (5) Fuel Temperature Sensor Circuit Malfunction |

| DTC No. | DTC Detection Condition | Trouble Area |
| 39 (5) | Open or short in fuel temperature sensor circuit for 0.5 sec. or more |
|

| 1.READ VALUE USING INTELLIGENT TESTER (FUEL TEMPERATURE) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON.
Enter the following menus: Powertrain / Engine and ECT / Data List / Fuel Temp.
| Display | Proceed to |
| -40°C (-40°F) | A |
| 140°C (284°F) or more | B |
| The same as actual fuel temperature | C |
| Temperature Displayed | Malfunction |
| -40°C (-40°F) | Open circuit |
| 140°C (284°F) or more | Short circuit |
|
| ||||
|
| ||||
| A | |
| 2.CHECK WIRE HARNESS (FOR OPEN) |
![]() |
Disconnect the F11 fuel temperature sensor connector.
Connect the sensor terminals 1 and 2 of the fuel temperature sensor harness side connector.
Turn the ignition switch ON.
Read the temperature value on the intelligent tester.
|
| ||||
| NG | |
| 3.CHECK ECM (FOR OPEN) |
![]() |
Connect terminals THF and E2 of the ECM connector.
Turn the ignition switch ON.
Read the temperature value on the intelligent tester.
|
| ||||
| OK | ||
| ||
| 4.CHECK WIRE HARNESS (FOR SHORT) |
![]() |
Disconnect the F11 fuel temperature sensor connector.
Turn the ignition switch ON.
Read the temperature value on the intelligent tester.
|
| ||||
| NG | |
| 5.CHECK ECM (FOR SHORT) |
Disconnect the E22 ECM connector.
Turn the ignition switch ON.
Read the temperature value on the intelligent tester.
|
| ||||
| OK | ||
| ||
| 1.CHECK ECM (THF VOLTAGE) |
![]() |
Turn the ignition switch ON.
Measure the voltage of the ECM connector.
| Tester Connection | Condition | Specified Condition |
| E22-5 (THF) - E22-9 (E2) | 20°C (68°F) | 0.2 to 3.8 V |
| E22-5 (THF) - E22-9 (E2) | 80°C (176°F) | 0.1 to 1.5 V |
|
| ||||
| NG | |
| 2.INSPECT FUEL TEMPERATURE SENSOR |
![]() |
Measure the resistance of the fuel temperature sensor.
|
| ||||
| OK | |
| 3.CHECK WIRE HARNESS (ECM - FUEL TEMPERATURE SENSOR) |
![]() |
Disconnect the F11 fuel temperature sensor connector.
Disconnect the E22 ECM connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| F11-2 - E22-5 (THF) | Below 1 Ω |
| F11-1 - E22-9 (E2) | Below 1 Ω |
| E22-5 (THF) - E22-9 (E2) | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||