REAR PROPELLER SHAFT ASSEMBLY (for TMT Made) > INSPECTION |
| 1. INSPECT PROPELLER SHAFT AND INTERMEDIATE SHAFT |
![]() |
Using a dial indicator, measure the propeller shaft and intermediate shaft runout.
| Item | Specified Condition |
| Propeller shaft | 0.3 mm (0.012 in.) |
| Intermediate shaft | 0.5 mm (0.02 in.) |
| 2. INSPECT UNIVERSAL JOINT SPIDER ASSEMBLY |
Check the spider bearings for wear or damage.
Check each spider bearing's axial play by turning the yoke while holding the shaft tightly.
| 3. INSPECT CENTER NO. 1 SUPPORT BEARING ASSEMBLY |
![]() |
When turning the center bearing with your hand, check that it turns smoothly without catching, and that there are no cracks or damage.
If there are any defects, replace it.
If there is any damage to the lip of the center bearing case, replace it.