Home › ENGINE ยท 1KD-FTV › STARTING › STARTER (for 2.7 kW Type)

STARTER (for 2.7 kW Type) > DISASSEMBLY

for Preparation Click here



1. REMOVE STARTER YOKE ASSEMBLY


    A115884E01
  1. Remove the nut and disconnect the lead wire from terminal C.

  1. Remove the 2 through bolts.

  1. Pull out the starter yoke together with the armature.

  1. Remove the felt washer from the armature.



2. REMOVE STARTER CLUTCH SUB-ASSEMBLY


    A102626
  1. Remove the 3 screws and magnet starter switch assembly.



  1. Remove the return spring, idler gear, clutch roller, retainer and starter clutch assembly from the starter drive housing.


    A122572E02



    A197146E02
  1. Using a magnet hand, remove the steel ball from the clutch shaft hole.



3. REMOVE STARTER BRUSH HOLDER ASSEMBLY


    A102628
  1. Remove the 2 screws and commutator end frame from the starter yoke.



    A102629
  1. Disconnect the 4 starter brushes from the starter brush holder.

    1. Using a screwdriver, pull back the spring.

    2. Disconnect the brush from the brush holder.

  1. Remove the starter brush holder from the starter yoke.



4. REMOVE STARTER ARMATURE ASSEMBLY