Home › BRAKE › BRAKE › FRONT BRAKE FLEXIBLE HOSE (for 4WD and Pre-Runner)

FRONT BRAKE FLEXIBLE HOSE (for 4WD and Pre-Runner) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.



1. REMOVE FRONT WHEEL


2. DRAIN BRAKE FLUID

NOTICE:
Wash off brake fluid immediately if it comes in contact with any painted surface.



3. REMOVE FRONT FLEXIBLE HOSE


C111390
  1. Remove the brake tube and wheel cylinder tube from the flexible hose with SST while holding the flexible hose with a wrench.

    SST
    09023-00101  

    NOTICE:
    1. Do not bend or damage the brake tube and wheel cylinder tube.
    2. Do not allow any foreign matter such as dirt and dust to enter the brake tube and wheel cylinder tube from the connecting points.

  1. Remove the 2 clips and flexible hose.



4. REMOVE FRONT NO. 1 WHEEL CYLINDER TUBE LH


C111391
  1. Using SST, remove the wheel cylinder tube from the brake cylinder.

    SST
    09023-00101  

    NOTICE:
    1. Do not bend or damage the wheel cylinder tube.
    2. Do not allow any foreign matter such as dirt and dust to enter the wheel cylinder tube from the connecting points.