Home › BODY ELECTRICAL › LIGHTING › HEADLIGHT ASSEMBLY

HEADLIGHT ASSEMBLY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT HEADLIGHT ASSEMBLY (w/ HEADLIGHT BEAM LEVEL CONTROL ACTUATOR OPERATION)


B113717E02
  1. Disconnect the headlight beam level control actuator connector.

  1. Connect the battery's positive (+) lead to headlight leveling switch terminal 1 and negative (-) lead to headlight leveling switch terminal 2.

  1. Connect the battery's positive (+) lead to each of the headlight beam level control actuator terminals (3) and the negative (-) lead to each of the headlight beam level control actuator terminals (1).

  1. Connect headlight leveling switch terminal 4 and LH side headlight beam level control actuator terminal 2.

  1. Connect headlight leveling switch terminal 5 and RH side headlight beam level control actuator terminal 2.

  1. Inspect the headlight beam level control actuator operation when the headlight leveling switch is operated.

    OK:
    Headlight beam leveling control actuators are operated.

    If the result is not as specified, replace the headlight assembly.