Home › TRANSMISSION ยท A343E AUTOMATIC TRANSMISSION › EXTENSION HOUSING REAR OIL SEAL

EXTENSION HOUSING REAR OIL SEAL > REPLACEMENT

for Preparation Click here



1. DRAIN AUTOMATIC TRANSMISSION FLUID
  1. Remove the drain plug and gasket, and drain ATF.

  1. Install a new gasket and the drain plug.

    Torque:
    20 N*m{ 205 kgf*cm , 15 ft.*lbf }



2. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
  1. Remove the propeller with center bearing shaft (Click here).



3. REMOVE AUTOMATIC TRANSMISSION EXTENSION HOUSING OIL SEAL


D028697E01
  1. Using SST, remove the oil seal.



4. INSTALL AUTOMATIC TRANSMISSION EXTENSION HOUSING OIL SEAL


G037608E01
  1. Coat the lip of a new oil seal with MP grease.

  1. Using SST and a hammer, tap in the oil seal.

    Standard oil seal depth:
    0 +/-0.5 mm (0 +/-0.020 in.)

    NOTICE:
    Be careful not to damage the lip of the oil seal.



5. INSTALL PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
  1. Install the propeller with center bearing shaft (Click here).



6. ADD AUTOMATIC TRANSMISSION FLUID

Fluid type:
Toyota Genuine ATF Type T-IV



7. CHECK AUTOMATIC TRANSMISSION FLUID
  1. Inspect the automatic transmission fluid (Click here).