Home › BRAKE › BRAKE CONTROL › SKID CONTROL BUZZER (w/ VSC)

SKID CONTROL BUZZER (w/ VSC) > REMOVAL

for Preparation Click here




1. PRECAUTION

CAUTION:
Be sure to read the "PRECAUTION" thoroughly before servicing (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY
  1. Remove the upper instrument panel sub-assembly (Click here).



4. REMOVE SKID CONTROL BUZZER ASSEMBLY

HINT:
This illustration is for RHD vehicles. For LHD vehicles, the components' positions are on the opposite side.



    C189948
  1. Detach the clamp and remove the buzzer.

  1. Disconnect the buzzer connector.