TURBOCHARGER (w/ EGR Cooler) > REASSEMBLY |
| 1. INSTALL ACTUATOR ASSEMBLY WITH BRACKET (for Vacuum Controlled Actuator) |
![]() |
Using SST, apply pressure to the actuator.
![]() |
Install the actuator with the 2 bolts and E-ring.
![]() |
Set the dial indicator as shown in the illustration.
Using SST, apply 114 kPa (1.16 kgf/cm2, 16.4 psi) of pressure to the actuator, and measure the push rod stroke.
Select the plate washer according to the table below.
| Stroke measurement mm (in.) | Required plate washer thickness mm (in.) |
| 1.20 to 1.70 (0.0472 to 0.0669) | - |
| 1.71 to 2.20 (0.0673 to 0.0866) | 0.5 (0.020) |
| 2.21 to 2.70 (0.0870 to 0.1063) | 1.0 (0.039) |
| 2.71 to 3.20 (0.1067 to 0.1260) | 1.5 (0.059) |
| 3.21 to 3.70 (0.1264 to 0.4517) | 2.0 (0.079) |
| 3.71 to 4.20 (0.1461 to 0.1654) | 2.5 (0.098) |
| 4.21 to 4.70 (0.1657 to 0.1850) | 3.0 (0.118) |
| 4.71 to 5.20 (0.1854 to 0.2047) | 3.5 (0.138) |
| 5.21 to 5.70 (0.2051 to 0.2244) | 4.0 (0.157) |
| 5.71 to 6.20 (0.2248 to 0.2441) | 4.5 (0.177) |
| 6.21 to 6.70 (0.2445 to 0.2638) | 5.0 (0.197) |
| 6.71 to 7.20 (0.2642 to 0.2827) | 5.5 (0.217) |
| 7.21 to 7.70 (0.2839 to 0.3031) | 6.0 (0.236) |
| 7.71 to 8.20 (0.3035 to 0.3228) | 6.5 (0.256) |
Using SST, apply 114 kPa (1.16 kgf/cm2, 16.4 psi) of pressure to the actuator, and install the selected plate washers between the actuator and compressor housing with the 2 bolts and E-ring.
Using SST, apply 114 kPa (1.16 kgf/cm2, 16.4 psi) of pressure to the actuator, and measure the actuator push rod stroke.
Connect the actuator hose.
Remove SST.
Apply yellow paint from the actuator bolts to the actuator bracket to indicate that they have been correctly installed.