FUEL INJECTOR (w/ EGR Cooler) > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. LOOSEN FUEL TANK CAP ASSEMBLY |
| 3. DRAIN FUEL |
| 4. REMOVE INTERCOOLER ASSEMBLY |
Remove the intercooler (Click here).
| 5. CHECK FOR INJECTOR COMPENSATION CODE |
Read the injector compensation code .
Check that compensation code of installed injector is same as code registered in ECM. If the code is not as specified, register the injector compensation code on the injector (Click here).
| 6. REMOVE NO. 1, NO. 2 AND NO. 3 INJECTION PIPE |
![]() |
Remove the 2 nuts and No. 3 injection pipe clamp.
![]() |
Remove the 2 bolts and 2 No. 2 injection pipe clamps.
![]() |
Using a 17 mm union nut wrench, loosen the union nuts and remove the No. 1, No. 2 and No. 3 injection pipes.
| 7. REMOVE EGR COOLER ASSEMBLY |
Remove the EGR cooler (Click here).
| 8. REMOVE NO. 4 INJECTION PIPE |
![]() |
Remove the bolt and disconnect the injection pipe clamp.
![]() |
Using a 17 mm union nut wrench, loosen the union nuts and remove the No. 4 injection pipe.
| 9. REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY |
![]() |
Remove the 3 bolts and disconnect the 4 connectors.
![]() |
Using a small screwdriver, remove the holder seal by prying the portion between the holder seal and the cutout part of the cylinder head.
Disconnect the ventilation hose.
![]() |
Remove the 10 bolts, 2 nuts, cylinder head cover and gasket.
| 10. REMOVE INJECTOR ASSEMBLY |
![]() |
Remove the union bolt, 4 hollow screws, 5 gaskets and nozzle leakage pipe.
![]() |
Remove the 4 bolts, 4 washers, 4 nozzle holder clamps and 4 injectors.
Remove the O-ring and back-up ring from each injector.
Remove the 4 injection nozzle sheets from the cylinder head.