Home › ENGINE · 1KD-FTV › FUEL › COMMON RAIL (w/o EGR Cooler)

COMMON RAIL (w/o EGR Cooler) > INSPECTION

for Preparation Click here



1. INSPECT COMMON RAIL ASSEMBLY


    A075928E01
  1. Inspect the fuel pressure sensor.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      2 - 3
      25°C (77°F)
      16.4 kΩ or less
      5 - 4
      25°C (77°F)
      16.4 kΩ or less
      1 - 2
      25°C (77°F)
      3 kΩ or less
      6 - 5
      25°C (77°F)
      3 kΩ or less

      If the result is not as specified, replace the common rail assembly.

  1. Inspect the pressure discharge valve.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      20°C (68°F)
      0.85 to 1.05 Ω

      If the result is not as specified, replace the common rail assembly.