FUEL SUPPLY PUMP (w/ EGR Cooler) > INSTALLATION |
| 1. INSTALL SUPPLY PUMP ASSEMBLY |
![]() |
Check that the supply pump gear in the timing gear case moves back and forth smoothly.
Install a new O-ring to the pump.
Apply a light coat of engine oil to the O-ring.
![]() |
Align the set key on the drive shaft with the groove of the injection gear.
![]() |
Install the pump with the 2 nuts.
Set a new O-ring.
![]() |
Using SST, hold the crankshaft pulley and install the set nut.
![]() |
Using a dial indicator, measure the thrust clearance of the injection pump shaft by moving the pump drive shaft pulley back and forth.
![]() |
Connect the 2 connectors.
![]() |
Connect the 2 fuel hoses.
| 2. INSTALL FUEL INLET PIPE SUB-ASSEMBLY |
![]() |
Temporarily install the fuel inlet pipe with the union nuts.
Install a new O-ring to the oil level gauge guide, and install the oil level gauge guide to the cylinder block.
![]() |
Temporarily install the stay of the oil level gauge guide to the intake manifold with the bolt.
![]() |
Install the clamp with the bolt.
Tighten the bolt of the oil level gauge guide stay.
![]() |
Using a 17 mm union nut wrench, tighten the injection pipe union nut on the common rail side.
Using a 17 mm union nut wrench, tighten the injection pipe union nut on the supply pump side.
| 3. INSTALL TIMING BELT |
Install the timing belt (Click here).
| 4. INSTALL RADIATOR ASSEMBLY |
Install the radiator assembly (Click here).
| 5. ADD AUTOMATIC TRANSMISSION FLUID |
| 6. ADD FUEL |
| 7. TIGHTEN FUEL TANK CAP ASSEMBLY |
| 8. BLEED AIR FROM FUEL SYSTEM |
| 9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 10. PERFORM INITIALIZATION |
Perform initialization (Click here).
| 11. CHECK FUEL SUPPLY PUMP INITIALIZATION |
Initialize the fuel supply pump (Click here).
| 12. START ENGINE |
| 13. CHECK ENGINE COOLANT LEAKS |
| 14. CHECK FOR OIL LEAKS |
| 15. CHECK FOR FUEL LEAKS |
| 16. INSTALL NO. 2 ENGINE UNDER COVER |
Install the under cover with the 4 bolts.
| 17. INSTALL NO. 1 ENGINE UNDER COVER |
Install the under cover with the 4 bolts.