CAN COMMUNICATION SYSTEM (w/ VSC) > ECM Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| ECM Communication Stop Mode | When either condition below is met:
|
|

| 1.CHECK HARNESS AND CONNECTOR (ECM - BATTERY AND BODY GROUND) |
Disconnect the E5, E6, E7 and E8 ECM connectors.

Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E7-7 (E1) - Body ground | Always | Below 1 Ω |
| E8-6 (E02) - Body ground | ||
| E8-7 (E01) - Body ground |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| E5-1 (+B) - Body ground | When battery's positive (+) voltage is applied to terminal MREL | 11 to 14 V |
| E6-2 (BATT) - Body ground | Always |
|
| ||||
| OK | ||
| ||