CAN COMMUNICATION SYSTEM (w/ VSC) > Open in One Side of CAN Branch Line |
| Symptom | Trouble Area |
| 2 or more ECUs and/or sensors do not appear on intelligent tester "Bus Check" screen. |
|

| 1.CHECK FOR OPEN IN ONE SIDE OF CAN BRANCH WIRE (SKID CONTROL ECU) |
Disconnect the S35 skid control ECU connector.
Select "Bus Check" on the intelligent tester.
| Result | Proceed to |
| ABS/VSC/TRC not displayed on intelligent tester. | A |
| Several ECUs and sensors other than ABS/VSC/TRC not displayed on intelligent tester. | B |
|
| ||||
| A | |
| 2.CHECK FOR OPEN IN ONE SIDE OF CAN BRANCH WIRE (SKID CONTROL ECU BRANCH WIRE) |
Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire and the branch wire.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| S35-25 (CANH) - S35-14 (CANL) | Ignition switch off | 54 to 69 Ω |
| Result | Proceed to |
| OK (for LHD) | A |
| OK (for RHD) | B |
| NG | C |
|
| ||||
|
| ||||
| A | ||
| ||
| 3.CHECK FOR OPEN IN ONE SIDE OF CAN BRANCH WIRE (STEERING ANGLE SENSOR) |
Disconnect the S37 steering angle sensor connector.
Select "Bus Check" on the intelligent tester.
| Result | Proceed to |
| Steering Angle Sensor not displayed on intelligent tester. | A |
| Several ECUs and sensors other than Steering Angle Sensor not displayed on intelligent tester. | B |
|
| ||||
| A | |
| 4.CHECK FOR OPEN IN ONE SIDE OF CAN BRANCH WIRE (STEERING ANGLE SENSOR BRANCH WIRE) |
Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire and the branch wire.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| S37-4 (CANH) - S37-3 (CANL) | Ignition switch off | 54 to 69 Ω |
|
| ||||
| OK | ||
| ||
| 5.CHECK FOR OPEN IN ONE SIDE OF CAN BRANCH WIRE (YAW RATE SENSOR BRANCH WIRE) |
Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire and the branch wire.
![]() |
Disconnect the Y1 yaw rate sensor connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| Y1-3 (CANH) - Y1-2 (CANL) | Ignition switch off | 54 to 69 Ω |
|
| ||||
| OK | ||
| ||