TRANSPONDER KEY AMPLIFIER > INSTALLATION |
| 1. INSTALL TRANSPONDER KEY AMPLIFIER |
![]() |
Align the claw of the amplifier with the upper bracket.
Push in the amplifier and install it to the upper bracket.
Connect the amplifier connector.
| 2. INSTALL UPPER STEERING COLUMN COVER |
![]() |
Install the cover lower with the 3 screws.
| 3. INSTALL LOWER STEERING COLUMN COVER |
![]() |
Install the cover lower with the 3 screws.
| 4. INSTALL STEERING WHEEL ASSEMBLY (w/ Airbag System, w/ Steering Pad Switch) |
![]() |
Align the matchmarks on the steering wheel and main shaft.
Install the steering wheel with the set nut.
![]() |
Connect the steering pad switch connector.
| 5. INSTALL STEERING WHEEL ASSEMBLY (w/ Airbag System, w/o Steering Pad Switch) |
![]() |
Align the matchmarks on the steering wheel and main shaft.
Install the steering set nut.
| 6. INSTALL STEERING WHEEL ASSEMBLY (w/o Airbag System, w/o Steering Pad Switch) |
![]() |
Align the matchmarks on the steering wheel and main shaft.
Install the steering set nut.
| 7. INSTALL STEERING PAD ASSEMBLY (w/ Airbag System, w/ Steering Pad Switch) |
![]() |
Support the steering pad with one hand as shown in the illustration.
Connect the airbag connector.
Connect the horn connector.
Install the steering pad after confirming that the circumference grooves of the screws are caught on the screw case.
Using a T30 "torx" socket, install the 2 screws.
| 8. INSTALL STEERING PAD ASSEMBLY (w/ Airbag System, w/o Steering Pad Switch) |
![]() |
Support the steering pad with one hand as shown in the illustration.
Connect the airbag connector.
Connect the horn connector.
Install the steering pad after confirming that the circumference grooves of the screws are caught on the screw case.
Using a T30 "torx" socket, install the 2 screws.
| 9. INSTALL STEERING PAD ASSEMBLY (w/o Airbag System, w/o Steering Pad Switch) |
for Type A:
![]() |
Attach the 4 claws shown in the illustration to the steering wheel to install the steering pad.
for Type B:
Connect the horn connector.
![]() |
Attach the 3 clips shown in the illustration to the steering wheel to install the steering pad.
![]() |
Install the screw.
| 10. INSTALL LOWER NO. 3 STEERING WHEEL COVER (w/ Airbag System, w/ Steering Pad Switch) |
![]() |
Attach the 2 claws to install the cover.
| 11. INSTALL LOWER NO. 2 STEERING WHEEL COVER (w/ Airbag System, w/ Steering Pad Switch) |
![]() |
Attach the 2 claws to install the cover.
| 12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 13. CHECK SRS WARNING LIGHT |
For vehicles with SRS:
Check the SRS warning light (Click here).
| 14. CHECK ENGINE START |
Start the engine. Then check that the engine idles.