CRUISE CONTROL SYSTEM > Clutch Switch Circuit |


| 1.INSPECT FUSE (ECU-IG & GAUGE) |
Remove the ECU-IG & GAUGE fuse from the driver side junction block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| ECU-IG & GAUGE fuse | Always | Below 1 Ω |
|
| ||||
| OK | |
| 2.INSPECT ECM |
![]() |
Disconnect the E13*1 or E6*2 ECM connector.
*1: for 1GR-FE
*2: for 1KD-FTV
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| E13-21 (D) - Body ground | Ignition switch ON Clutch pedal depressed | Below 1 V |
| Ignition switch ON Clutch pedal released | 11 to 14 V |
| Tester Connection | Switch Condition | Specified Condition |
| E6-10 (CLSW) - Body ground | Ignition switch ON Clutch pedal depressed | Below 1 V |
| Ignition switch ON Clutch pedal released | 11 to 14 V |
|
| ||||
| OK | ||
| ||
| 3.INSPECT CLUTCH SWITCH ASSEMBLY |
![]() |
Remove the clutch switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 1 - 2 | Pin pushed | Below 1 Ω |
| Pin not pushed | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (ECM - CLUTCH SWITCH) |
![]() |
Disconnect the E13*1 or E6*2 ECM connector.
*1: for 1GR-FE
*2: for 1KD-FTV
Disconnect the C20 clutch switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E13-21 (D) - C20-2 | Always | Below 1 Ω |
| E13-21 (D) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
| E6-10 (CLSW) - C20-2 | Always | Below 1 Ω |
| E6-10 (CLSW) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||