Home › BODY › EXTERIOR › FRONT BUMPER

FRONT BUMPER > REMOVAL

for Preparation Click here



1. REMOVE RADIATOR GRILLE ASSEMBLY


B206025E01
  1. Using a clip remover, remove the 2 clips.

  1. Remove the 2 screws.

  1. Put protective tape around the radiator grille.

  1. Detach the 6 claws and remove the radiator grille.



2. REMOVE FRONT NO. 1 WHEEL OPENING EXTENSION PAD (for 4WD and Pre-Runner)


B206026
  1. Remove the 2 screws and extension pad.

    HINT:
    Use the same procedures to remove the extension pad on the other side.



3. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH


B206027
  1. Remove the 4 screws.

  1. Using a clip remover, remove the 3 clips.

  1. Partially remove the splash shield.

    HINT:
    It is not necessary to fully remove the splash shield. Partially remove it so that the bumper cover can be removed in a later step.



4. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.



5. REMOVE ENGINE SIDE COVER SUB-ASSEMBLY LH (for 4WD and Pre-Runner)


B206028
  1. Using a clip remover, remove the 2 clips.

  1. Remove the 3 bolts and engine side cover.



6. REMOVE ENGINE SIDE COVER SUB-ASSEMBLY RH (for 4WD and Pre-Runner)

HINT:
Use the same procedures described for the LH side.



7. REMOVE FRONT BUMPER COVER


B206029
  1. Remove the 2 bolts.

  1. Using a clip remover, remove the 7 clips.



    B206030E01
  1. Put protective tape around the bumper cover.

  1. Detach the 6 claws and remove the bumper cover.

  1. w/ Fog Light:
    Disconnect the 2 fog light connectors.

  1. w/ Headlight Cleaner System:
    Disconnect the headlight cleaner hose.



8. REMOVE FRONT BUMPER SIDE SUPPORT LH


B085200E01
  1. Remove the screw.

  1. Using a screwdriver, detach the 2 claws and remove the side support.

    HINT:
    Tape the screwdriver tip before use.



9. REMOVE FRONT BUMPER SIDE SUPPORT RH

HINT:
Use the same procedures described for the LH side.



10. REMOVE FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY


B085202
  1. Remove the 4 nuts and reinforcement.



11. REMOVE FRONT BUMPER REINFORCEMENT EXTENSION LH (for 4WD and Pre-Runner)
  1. Using a screwdriver, detach the claws and remove the reinforcement extension.

    HINT:
    Tape the screwdriver tip before use.



12. REMOVE FRONT BUMPER REINFORCEMENT EXTENSION RH (for 4WD and Pre-Runner)

HINT:
Use the same procedures described for the LH side.