DTC C1282/82 Center Differential Lock Position Switch Malfunction (Test Mode DTC) |
| DTC Code | DTC Detection Condition | Trouble area |
| C1282/82 | Detected only during test mode. |
|

| 1.INSPECT SKID CONTROL ECU |
![]() |
Turn the ignition switch off.
Disconnect the skid control ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S35-20 (EXI) - Body ground |
| 11 to 14 V |
| S35-20 (EXI) - Body ground |
| Below 1.5 V |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - A.D.D. ACTUATOR) |

Turn the ignition switch off.
Disconnect the skid control ECU connector.
Disconnect the A.D.D. actuator connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S35-20 (EXI) - A3-3 (ADD) | Always | Below 1 Ω |
| S35-20 (EXI) - Body ground | Always | 10 kΩ or higher |
| A3-4 (GND) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||