Home › BODY › SEAT › POWER SEAT SWITCH

POWER SEAT SWITCH > INSPECTION

for Preparation Click here



1. INSPECT FRONT POWER SEAT SWITCH


    B206190E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Reclining Switch:
    Tester Connection
    Switch Condition
    Specified Condition
    1 (B) - 3 (RCLF)
    Front
    Below 1 Ω
    2 (RCLR) - 4 (E)
    3 (RCLF) - 4 (E)
    Off
    2 (RCLR) - 4 (E)
    1 (B) - 2 (RCLR)
    Rear
    3 (RCLF) - 4 (E)

    Slide Switch:
    Tester Connection
    Switch Condition
    Specified Condition
    1 (B) - 9 (SLDF)
    Front
    Below 1 Ω
    6 (SLDR) - 4 (E)
    9 (SLDF) - 4 (E)
    Off
    6 (SLDR) - 4 (E)
    1 (B) - 6 (SLDR)
    Rear
    9 (SLDF) - 4 (E)

    Rear Lifter Switch:
    Tester Connection
    Switch Condition
    Specified Condition
    1 (B) - 8 (LUP)
    Up
    Below 1 Ω
    7 (LDWN) - 4 (E)
    8 (LUP) - 4 (E)
    Off
    7 (LDWN) - 4 (E)
    1 (B) - 7 (LDWN)
    Down
    8 (LUP) - 4 (E)

    If the result is not as specified, replace the front power seat switch.