VEHICLE STABILITY CONTROL SYSTEM > Slip Indicator Light Remains ON |
| 1.CHECK FOR DTC |
Check for DTCs (Click here).
| Result | Proceed to |
| DTC not output | A |
| DTC output | B |
|
| ||||
| A | |
| 2.READ VALUE USING INTELLIGENT TESTER (TRC/VSC OFF MODE) |
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to on and the intelligent tester on.
Select the Data List mode on the intelligent tester (Click here).
| Tester Display | Measurement Item / Range | Normal Condition | Diagnostic Note |
| TRC/VSC Off Mode | VSC OFF switch / Normal, TRC OFF, Unknown or VSC OFF | Normal: Normal mode TRC OFF: TRC off mode VSC OFF: VSC off mode | - |
Using the intelligent tester, check that the condition on the intelligent tester changes according to VSC OFF switch operation.
|
| ||||
| OK | |
| 3.READ VALUE USING INTELLIGENT TESTER (SLIP INDICATOR LIGHT) |
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and the tester on.
Select the Data List mode on the intelligent tester (Click here).
| Tester Display | Measurement Item / Range | Normal Condition | Diagnostic Note |
| Slip Indicator Light | Slip indicator light / ON or OFF | ON: Slip indicator light ON OFF: Slip indicator light OFF | - |
Perform the Active Test of the skid control ECU using the intelligent tester (Click here).
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Slip Indicator Light | Slip indicator light | Indicator light ON / OFF | Observe combination meter |
| Result | Proceed to | |
| Data List Display | Data List Display When Performing Active Test ON/OFF Operation | |
| ON | Does not change between ON and OFF | A |
| Changes between ON and OFF | B | |
| OFF | Does not change between ON and OFF | A |
| Changes between ON and OFF | B | |
|
| ||||
| A | ||
| ||
| 4.INSPECT VSC OFF SWITCH |
![]() |
Turn the ignition switch off.
Remove the VSC OFF switch (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 3 - 4 | Switch is pushed and held | Below 1 Ω |
| 3 - 4 | Switch is not pushed | 10 kΩ or higher |
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - VSC OFF SWITCH) |

Turn the ignition switch off.
Disconnect the VSC OFF switch connector.
Disconnect the skid control ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S35-30 (CSW) - V8-3 | Always | Below 1 Ω |
| S35-30 (CSW) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 6.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU EXI3 TERMINAL) |
![]() |
Turn the ignition switch off.
Disconnect the skid control ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| S35-28 (EXI3) - Body ground | Ignition switch ON | 11 to 14 V |
|
| ||||
| OK | ||
| ||