VEHICLE STABILITY CONTROL SYSTEM > Slip Indicator Light does not Come ON |
| 1.CHECK IF SKID CONTROL ECU CONNECTOR IS SECURELY CONNECTED |
Check if the skid control ECU connector is securely connected.
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU IG1 TERMINAL) |
![]() |
Turn the ignition switch off.
Disconnect the skid control ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| S35-34 (IG1) - Body ground | Ignition switch ON | 11 to 14 V |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU GND1 TERMINAL) |
![]() |
Turn the ignition switch off.
Disconnect the skid control ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S35-1 (GND1) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 4.INSPECT VSC OFF SWITCH |
![]() |
Turn the ignition switch off.
Remove the VSC OFF switch (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 3 - 4 | Switch is pushed and held | Below 1 Ω |
| 3 - 4 | Switch is not pushed | 10 kΩ or higher |
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - VSC OFF SWITCH) |

Turn the ignition switch off.
Disconnect the VSC OFF switch connector.
Disconnect the skid control ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S35-30 (CSW) - V8-3 | Always | Below 1 Ω |
| S35-30 (CSW) - Body ground | Always | 10 kΩ or higher |
| V8-4 - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 6.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (SLIP INDICATOR LIGHT) |
Perform the Active Test of the skid control ECU using the intelligent tester (Click here).
Check the Data List.
|
| ||||
| OK | ||
| ||