AUDIO AND VISUAL SYSTEM > TERMINALS OF ECU |
| CHECK RADIO RECEIVER ASSEMBLY (w/o Steering Pad Switch) |

Disconnect the R1 receiver connector.
Measure the resistance and voltage of the wire harness side connector.
| Terminal No. (Symbols) | Wiring Color | Terminal Description | Condition | Specified Condition |
| R1-7 (GND) - Body ground | BR - Body ground | Ground | Always | Below 1 Ω |
| R1-3 (ACC) - Body ground | GR - Body ground | ACC power supply | Ignition switch ACC | 11 to 14 V |
| R1-4 (+B) - Body ground | L-Y - Body ground | Battery power supply | Always | 11 to 14 V |
| R1-10 (ILL) - Body ground | G - Body ground | Illumination signal | Light control switch TAIL | 11 to 14 V |
Reconnect the R1 receiver connector.
Measure the voltage of the connector.
| Terminal No. (Symbols) | Wiring Color | Terminal Description | Condition | Specified Condition |
| R2-1 (RR+) - R1-7 (GND)*1 | R - BR | Sound signal (rear right) | Audio system is operating | Waveform synchronized with sound is output |
| R2-2 (RL+) - R1-7 (GND)*1 | B - BR | Sound signal (rear left) | Audio system is operating | Waveform synchronized with sound is output |
| R2-3 (RR-) - R1-7 (GND)*1 | W - BR | Sound signal (rear right) | Audio system is operating | Waveform synchronized with sound is output |
| R2-6 (RL-) - R1-7 (GND)*1 | Y - BR | Sound signal (rear left) | Audio system is operating | Waveform synchronized with sound is output |
| R1-1 (FR+) - R1-7 (GND) | LG - BR | Sound signal (front right) | Audio system is operating | Waveform synchronized with sound is output |
| R1-2 (FL+) - R1-7 (GND) | P - BR | Sound signal (front left) | Audio system is operating | Waveform synchronized with sound is output |
| R1-5 (FR-) - R1-7 (GND) | L - BR | Sound signal (front right) | Audio system is operating | Waveform synchronized with sound is output |
| R1-6 (FL-) - R1-7 (GND) | V - BR | Sound signal (front left) | Audio system is operating | Waveform synchronized with sound is output |
| R1-8 (ANT) - R1-7 (GND)*2 | B-W - BR | Antenna amplifier | Ignition switch ON, radio switch ON and AM or FM radio on | 11 to 14V |
| CHECK RADIO RECEIVER ASSEMBLY (w/ Steering Pad Switch) |

Disconnect the R1 receiver connector.
Measure the resistance and voltage according to the value(s) in the table below.
| Terminal No. (Symbols) | Wiring Color | Terminal Description | Condition | Specified Condition |
| R1-7 (GND) - Body ground | BR - Body ground | Ground | Always | Below 1 Ω |
| R1-3 (ACC) - Body ground | GR - Body ground | ACC power supply | Ignition switch ACC | 11 to 14 V |
| R1-4 (+B) - Body ground | L-Y - Body ground | Battery power supply | Always | 11 to 14 V |
| R1-10 (ILL) - Body ground | G - Body ground | Illumination signal | Light control switch TAIL | 11 to 14 V |
Reconnect the R1 receiver connector.
Measure the voltage according to the value(s) in the table below.
| Terminal No. (Symbols) | Wiring Color | Terminal Description | Condition | Specified Condition |
| R2-1 (RR+) - R1-7 (GND)*1 | R - BR | Sound signal (rear right) | Audio system is operating | Waveform synchronized with sound is output |
| R2-2 (RL+) - R1-7 (GND)*1 | B - BR | Sound signal (rear left) | Audio system is operating | Waveform synchronized with sound is output |
| R2-3 (RR-) - R1-7 (GND)*1 | W - BR | Sound signal (rear right) | Audio system is operating | Waveform synchronized with sound is output |
| R2-6 (RL-) - R1-7 (GND)*1 | Y - BR | Sound signal (rear left) | Audio system is operating | Waveform synchronized with sound is output |
| R1-1 (FR+) - R1-7 (GND) | LG - BR | Sound signal (front right) | Audio system is operating | Waveform synchronized with sound is output |
| R1-2 (FL+) - R1-7 (GND) | P - BR | Sound signal (front left) | Audio system is operating | Waveform synchronized with sound is output |
| R1-5 (FR-) - R1-7 (GND) | L - BR | Sound signal (front right) | Audio system is operating | Waveform synchronized with sound is output |
| R1-6 (FL-) - R1-7 (GND) | V - BR | Sound signal (front left) | Audio system is operating | Waveform synchronized with sound is output |
| R12-7 (SW1) - R12-6 (SWG) | R - L | Steering pad switch signal | Steering pad switch not pushed | 4 V or higher |
| R12-7 (SW1) - R12-6 (SWG) | R - L | Steering pad switch signal | Steering pad switch Seek+ switch pushed | 0.1 V |
| R12-7 (SW1) - R12-6 (SWG) | R - L | Steering pad switch signal | Steering pad switch Seek- switch pushed | 0.9 V |
| R12-7 (SW1) - R12-6 (SWG) | R - L | Steering pad switch signal | Steering pad switch Vol+ switch pushed | 1.5 V |
| R12-7 (SW1) - R12-6 (SWG) | R - L | Steering pad switch signal | Steering pad switch Vol- switch pushed | 3 V |
| R12-8 (SW2) - R12-6 (SWG) | W - L | Steering pad switch signal | Steering pad switch not pushed | 4 V or higher |
| R12-8 (SW2) - R12-6 (SWG) | W - L | Steering pad switch signal | Steering pad switch MODE switch pushed | Below 0.1 V |
| R12-3 (SPD) - R1-7 (GND)*2 | V-R - BR | Speed signal | Ignition switch ON, drive wheels turned slowly | Pulse generation |
| R1-8 (ANT) - R1-7 (GND)*3 | B-W - BR | Antenna amplifier | Ignition switch ON, radio switch ON and AM or FM radio on | 11 to 14V |