Home › BODY ELECTRICAL › WIPER AND WASHER › HEADLIGHT CLEANER CONTROL RELAY

HEADLIGHT CLEANER CONTROL RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT HEADLIGHT CLEANER CONTROL RELAY


    E156165E02
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    6 (PB) - 4 (E)
    Battery voltage is not applied
    10 kΩ or higher
    Battery positive (+) → Terminal 3 (IG)
    Battery negative (-) → Terminal 5 (FEWA)
    Battery positive (+) → Terminal 3 (IG)
    Battery positive (+) → Terminal 2 (H)
    Battery negative (-) → Terminal 4 (E)
    Below 1 Ω for 0.8 to 0.9 seconds, then resistance increases by large amount
    Battery positive (+) → Terminal 1 (HDLO)
    Battery positive (+) → Terminal 3 (IG)
    Battery negative (-) → Terminal 5 (FRWA)

    If the result is not as specified, replace the headlight cleaner control relay.