Home › BRAKE › BRAKE › FRONT BRAKE (for TMT Made 2WD)

FRONT BRAKE (for TMT Made 2WD) > REASSEMBLY

for Preparation Click here


HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.



1. INSTALL FRONT DISC


C111369E01
  1. Align the matchmarks and install the disc.

    HINT:
    When replacing the disc with a new one, select the installation position where the disc has the smallest runout.



2. CHECK DISC RUNOUT


C192759
  1. Check the bearing play in the axial direction and the axle hub runout (Click here).

  1. Temporarily install the 5 hub nuts to the disc.

  1. Using a dial indicator, measure the disc runout 10.0 mm (0.39 in.) from the outer edge of the disc.

    Maximum disc runout:
    0.05 mm (0.0020 in.)

    If the runout is greater than the maximum, change the installation position of the disc so that the runout is as small as possible. If the runout is greater than the maximum even when the installation position is changed, grind the disc. If the disc thickness is less than the minimum, replace the disc.

  1. Remove the hub nuts and disc.



3. TEMPORARILY INSTALL FRONT DISC BRAKE BLEEDER PLUG
  1. Temporarily install the bleeder plug to the cylinder.

    HINT:
    The bleeder plug will be tightened to the torque specification in the "bleed air from brake line" procedures.

  1. Install the cap.



4. INSTALL PISTON SEAL
  1. Apply lithium soap base glycol grease to a new seal.

  1. Install the seal to the cylinder.



5. INSTALL FRONT DISC BRAKE PISTON


C111371E03
  1. Apply lithium soap base glycol grease to the piston and a new cylinder boot.

  1. Install the boot to the piston.

  1. Install the piston (with boot) to the cylinder.

    NOTICE:
    Do not forcibly install the piston to the cylinder.



6. INSTALL CYLINDER BOOT


C111372E01
  1. Install the boot into the grooves of the cylinder and piston.

    NOTICE:
    Make sure that the boot is securely installed into the grooves of the cylinder and piston.

  1. Using a screwdriver, install the set ring.

    NOTICE:
    Be careful not to damage the boot.



7. INSTALL FRONT DISC BRAKE CYLINDER MOUNTING LH


C111362
  1. Install the cylinder mounting with the 2 bolts.

    Torque:
    117 N*m{ 1193 kgf*cm , 86 ft.*lbf }



8. INSTALL FRONT DISC BRAKE PAD SUPPORT PLATE
  1. Install the 4 plates to the mounting.



9. INSTALL FRONT ANTI SQUEAL SHIM KIT


C195587E02
  1. Apply disc brake grease to both sides of each No. 1 shim.

  1. Install the No. 1 and No. 2 shims to each pad.

    NOTICE:
    1. When replacing worn pads, the shims must be replaced together with the pads.
    2. Install the shims in the correct position and direction.

  1. Install the pad wear indicator to the pad.



10. INSTALL FRONT DISC BRAKE PAD
  1. Install the 2 disc brake pads to the mounting.

    NOTICE:
    There should be no oil or grease on the friction surfaces of the pads and disc.