Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM

DTC    B279A    Theft Deterrent System Communication Line High Fixation

for Preparation Click here


DESCRIPTION

If the communication line (EFIO - IMI) to the transponder key ECU assembly is stuck on HI output, the ECM outputs this DTC.

DTC Code
DTC Detection Condition
Trouble Area
B279A
When the communication line (EFIO - IMI) between the ECM and transponder key ECU assembly is stuck on HI output.
  1. Harness or connector
  2. Transponder key ECU assembly
  3. ECM

WIRING DIAGRAM


B160072E16


INSPECTION PROCEDURE

1.CLEAR DTC
  1. Clear the DTC (Click here).


NEXT


2.CHECK FOR DTC
  1. Check for DTC (Click here).

    HINT:
    If any DTCs other than DTC B279A are output, troubleshoot those DTCs first.

    Result 
    Result
    Proceed to
    DTC B279A is output.
    A
    DTC B279A and other DTCs are output.
    B



B
Go to DIAGNOSTIC TROUBLE CODE CHART (Click here)
A


3.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - ECM)


    B215480E01
  1. Disconnect the T21 transponder key ECU assembly connector.

  1. Disconnect the E6 ECM connector.

  1. Measure the resistance and voltage according the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    T21-13 (EFIO) - E6-30 (IMI)
    Always
    Below 1 Ω
    T21-13 (EFIO) or E6-30 (IMI) - Body ground
    Always
    10 kΩ or higher

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    T21-13 (EFIO) - Body ground
    Always
    Below 1 V
    E6-30 (IMI) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK ECM (INPUT)


  1. Using an oscilloscope, check the waveform.


    B212532E01

    Measurement Condition  
    Item
    Content
    Terminal No. (Symbols)
    E6-30 (IMI) - E8-7 (E01)
    Tool Setting
    10 V/DIV., 100 msec./DIV.
    Condition
    Ignition switch ON

    OK:
    Waveform is output normally (See illustration).



NG
Go to step 5
OK

REPLACE TRANSPONDER KEY ECU ASSEMBLY 

5.CHECK TRANSPONDER KEY ECU ASSEMBLY (POWER SOURCE AND GROUND)
B212538E01
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    T21-1 (+B) - T21-16 (GND)
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ECM (Click here)