REAR AIRBAG SENSOR > INSTALLATION |
| 1. INSTALL REAR AIRBAG SENSOR LH |
![]() |
Check that the ignition switch is off.
Check that the cable is disconnected from the battery negative (-) terminal.
Install the rear airbag sensor with the bolt.
Check that there is no looseness in the installation parts of the rear airbag sensor.
Connect the connector.
| 2. INSTALL LOWER QUARTER TRIM PANEL LH |
![]() |
Attach the 3 clips and claw to install the trim panel.
| 3. INSTALL REAR DOOR OPENING TRIM LH |
| 4. INSTALL REAR DOOR SCUFF PLATE LH |
![]() |
Attach the 2 clips and 7 claws to install the scuff plate.
| 5. INSTALL REAR SEAT ASSEMBLY |
Install the rear seat assembly (Click here).
| 6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 7. CHECK SRS WARNING LIGHT |
Check the SRS warning light (Click here).