CRUISE CONTROL SYSTEM > DATA LIST / ACTIVE TEST |
| READ DATA LIST |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / Cruise Control / Data List.
According to the display on the intelligent tester, read the "Data List".
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| CCS Vehicle Spd | Vehicle speed / min.: 0 km/h (0 mph), max.: 255 km/h (158 mph) | Actual vehicle speed displayed | - |
| CCS Mem Vehicle Spd | Memory vehicle speed / min.: 0 km/h (0 mph), max.: 200 km/h (125 mph) | Actual vehicle speed stored in memory | - |
| Throttle Opening Angle*1 | Throttle opening angle / min.: 0 deg, max.: 125 deg | Actual required throttle opening angle | - |
| Throttle Opening Angle*2 | Throttle opening angle / min.: 0%, max.: 100% | Actual required throttle opening angle | - |
| Cruise Control | Cruise control system active condition / ON or OFF | ON: Cruise control system activated OFF: Cruise control system inactivated | - |
| CCS Main SW M-CPU | Cruise control main switch signal (Main CPU) / ON or OFF | ON: Cruise control main switch (Main CPU) on OFF: Cruise control main switch (Main CPU) off | - |
| CCS Ready M-CPU | Cruise control system standby condition (Main CPU) / ON or OFF | ON: Cruise control main switch (Main CPU) on OFF: Cruise control main switch (Main CPU) off | - |
| CCS Indicator M-CPU | Cruise main indicator signal (Main CPU) / ON or OFF | ON: CRUISE main indicator (Main CPU) on OFF: CRUISE main indicator (Main CPU) off | - |
| Cancel Switch | CANCEL switch signal / ON or OFF | ON: CANCEL switch on OFF: CANCEL switch off | - |
| SET/COAST Switch | (-SET)*3 (SET / COAST)*4 switch signal / ON or OFF | ON: (-SET)*3 (SET / COAST)*4 switch on ON: (-SET)*3 (SET / COAST)*4 switch off | - |
| RES/ACC Switch | (+RES)*3 (RES / ACC)*4 switch signal / ON or OFF | ON: (+RES)*3 (RES / ACC)*4 switch on OFF: (+RES)*3 (RES / ACC)*4 switch off | - |
| Stop Light SW M-CPU | Stop light switch signal (Main CPU) / ON or OFF | ON: Brake pedal depressed OFF: Brake pedal released | - |
| Cruise Operation Status*5 | PNP switch signal (D position) ON or OFF | ON: Shift lever on D or 4 OFF: Shift lever not on D or 4 | - |
| Cruise Operation Status*6 | PNP switch signal (D position) ON or OFF | ON: Shift lever on D or 3 OFF: Shift lever not on D or 3 | - |
| # Codes | Number of trouble codes / min.: 0, max.: 255 | - | - |