STARTER (for 2.2 kW Type Bosch Made) > REASSEMBLY |
| 1. INSTALL PLANET CARRIER SHAFT SUB-ASSEMBLY |
Install the 3 damper rubbers and the intermediate sealing to the planet carrier.
![]() |
Install the planet carrier shaft to the planet carrier.
Install the washer to the planet carrier shaft.
![]() |
Using a screwdriver and hammer, tap on a new snap ring.
| 2. INSTALL STARTER CLUTCH SUB-ASSEMBLY |
![]() |
Apply MP grease to the spline of the starter clutch sub-assembly and planet carrier shaft.
Install the starter clutch to the planet carrier shaft.
![]() |
Apply MP grease to a new snap ring and the pinion stop collar.
Install the pinion stop collar and snap ring.
![]() |
Using a vise, compress the snap ring.
![]() |
Using a plastic-faced hammer, lightly tap the planet carrier shaft while holding the outside of the starter clutch sub-assembly by hand until the pinion stop collar and snap ring are as shown in the illustration.
![]() |
Apply MP grease to the pinion drive lever.
![]() |
Install the starter clutch sub-assembly, pinion drive lever and cover to the starter drive housing.
![]() |
Apply MP grease to the planetary gears and pin parts of the planet carrier shaft.
Install the 3 planetary gears to the planet carrier.
| 3. INSTALL STARTER ARMATURE ASSEMBLY |
![]() |
Install the starter armature to the starter yoke.
| 4. INSTALL STARTER BRUSH HOLDER ASSEMBLY |
![]() |
Hold the starter yoke assembly between aluminum plates in a vise.
While compressing the springs, install the starter brush holder to the starter armature.
![]() |
Install the starter commutator end frame to the starter yoke.
Install the washer to the starter commutator end frame.
![]() |
Apply MP grease to the slotted washer and install it.
Install the seal ring.
![]() |
Install the starter commutator end frame cover to the starter commutator end frame with the 2 screws.
| 5. INSTALL STARTER YOKE ASSEMBLY |
![]() |
Fit the 3 claws of the plate into the 3 grooves of the planet carrier to install the plate to the planet carrier.
Install the cover ring to the planet carrier.
![]() |
Align the groove of the starter yoke assembly and the starter drive housing cover and install the starter yoke assembly to the starter drive housing.
![]() |
Install the 2 bolts.
| 6. INSTALL MAGNET STARTER SWITCH ASSEMBLY |
![]() |
Apply MP grease to the hook.
Install the plunger to the pinion drive lever.
![]() |
Install the return spring to the magnet starter switch assembly.
Using a T25 "TORX" socket wrench, install the magnet starter switch assembly with the 3 screws.
![]() |
Connect the lead wire to terminal C with the nut.