Home › TRANSMISSION · A340E AUTOMATIC TRANSMISSION › AUTOMATIC TRANSMISSION SYSTEM

DTC    P0560/96    System Voltage

for Preparation Click here


DESCRIPTION

The battery supplies power to the TCM even when the ignition switch is off. This power allows the TCM to store data such as DTC history, freeze frame data and fuel trim values. If the battery voltage falls below a minimum level, the TCM data is cleared and the TCM determines that there is a malfunction in the power supply circuit. The next time the engine is started, the TCM will illuminate the MIL and store the DTC.

DTC No.
DTC Detection Condition
Trouble Area
P0560/96
Open in the TCM back-up power source circuit (1 trip detection logic).
  1. Open in back-up power source circuit
  2. TCM

HINT:
If DTC P0560/96 is stored, the TCM does not store other DTCs.


WIRING DIAGRAM


C156221E01


INSPECTION PROCEDURE

1.CHECK TCM (BATTERY, GROUND)


    C193057E02
  1. Disconnect the T17 and T19 TCM connectors.

  1. Measure the voltage of the wire harness side connectors.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    T17-5 (BATT) - T19-1 (E1)
    Always
    11 to 14 V

  1. Measure the resistance of the wire harness side connector.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    T19-1 (E1) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (TCM - BATTERY, GROUND)
OK

REPLACE TCM