DTC P0617 Starter Relay Circuit High |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0617 | When conditions (a), (b) and (c) are met, positive (+B) battery voltage of 10.5 V or more applied to ECM for 20 seconds (1 trip detection logic): (a) Vehicle speed is more than 20 km/h (12.4 mph) (b) Engine speed is more than 1,000 rpm (c) STA signal is ON |
|

| 1.READ VALUE USING INTELLIGENT TESTER (STARTER SIGNAL) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the tester ON.
Select the following menu items: Powertrain / Engine and ECT / Data List / Starter Signal.
Check the value displayed on the tester when the ignition switch is turned to the ON and START positions.
| Ignition Switch Condition | Tester Display (Starter Signal) |
| ON | OFF |
| START | ON |
|
| ||||
| NG | |
| 2.INSPECT IGNITION SWITCH ASSEMBLY |
Disconnect the ignition switch connector.
![]() |
Measure the resistance of the ignition switch.
| Tester Condition | Switch Condition | Specified Condition |
| 5 (AM2) - 7 (ST2) | LOCK | 10 kΩ or higher |
| 5 (AM2) - 7 (ST2) | START | Below 1 Ω |
Reconnect the ignition switch connector.
|
| ||||
| NG | |
| 3.REPLACE IGNITION SWITCH ASSEMBLY |
Replace the ignition switch assembly (Click here).
| NEXT | |
| 4.READ VALUE USING INTELLIGENT TESTER (STARTER SIGNAL) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the tester ON.
Select the following menu items: Powertrain / Engine and ECT / Data List / Starter Signal.
Check the value displayed on the tester when the ignition switch is turned to the ON and START positions.
| Ignition Switch Condition | Tester Display (Starter Signal) |
| ON | OFF |
| START | ON |
|
| ||||
| NG | |
| 5.REPAIR OR REPLACE HARNESS AND CONNECTOR (IGNITION SWITCH - STA TERMINAL OF ECM) |
| NEXT | |
| 6.CHECK WHETHER DTC OUTPUT RECURS |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON.
Turn the tester ON.
Clear DTCs (Click here).
Drive the vehicle at more than 12.4 mph (20 km/h) for over 20 seconds.
Select the following menu items: Powertrain / Engine and ECT / Data List / DTC.
Read DTCs.
| Display (DTC Output) | Proceed to |
| P0617 | A |
| No DTC | B |
|
| ||||
| A | ||
| ||