Home › BRAKE › BRAKE › VACUUM PUMP (for 5L-E)

VACUUM PUMP (for 5L-E) > REASSEMBLY

for Preparation Click here



1. INSTALL OIL SEAL


    F000817E01
  1. Using SST and a hammer, tap in the oil seal.

    SST
    09950-60010   (09951-00400)
    09950-70010   (09951-07150)



2. INSTALL O-RING
  1. Apply engine oil on a new O-ring and install the O-ring to the vacuum pump case.



3. INSTALL VACUUM PUMP BEARING


    F043198
  1. Using a press, press in a new bearing to the pump shaft.



4. INSTALL VACUUM PUMP SHAFT
  1. Install the vacuum pump shaft and stop ring to the vacuum pump case.



5. INSTALL VACUUM PUMP BLADE


    F043199
  1. Apply engine oil to the rotor and 5 new vacuum pump blades.

  1. Install the rotor and pump blades with the round end facing outward.



    F043221
  1. Install the end plate with the 2 screws.

    Torque:
    2.0 N*m{ 20 kgf*cm , 17 in.*lbf }



6. INSTALL VACUUM PUMP END COVER


    F000813
  1. Install the end cover with the 4 screws.

    Torque:
    4.6 N*m{ 47 kgf*cm , 41 in.*lbf }



7. INSTALL BRAKE VACUUM CHECK VALVE ASSEMBLY


    F043197
  1. Using soft jaws, place the vacuum pump in a vise. Then install a new gasket and check valve.

    Torque:
    74 N*m{ 755 kgf*cm , 54 ft.*lbf }



8. INSTALL VACUUM PUMP VACUUM HOSE UNION


    F043220E01
  1. Using SST, hold the check valve, and install 2 new gaskets and the vacuum hose union with the union bolt.

    SST
    09922-10010  

    Torque:
    14 N*m{ 143 kgf*cm , 10 ft.*lbf }



9. INSTALL VACUUM PUMP PULLEY


    C106117
  1. Install the vacuum pump pulley with the pulley lock nut.

    Torque:
    105 N*m{ 1,075 kgf*cm , 78 ft.*lbf }