Home › ENGINE · 5L-E › ENGINE CONTROL SYSTEM › ECD SYSTEM

DTC    12    Crankshaft Position Sensor Circuit Malfunction

for Preparation Click here


DESCRIPTION

The crankshaft position sensor in the Engine Control System contains a signal plate and a pickup coil for TDC signal. The TDC signal plate has 1 tooth on its outer circumference. The TDC signal sensor generates 1 signal for every engine revolution. The ECM detects the top dead center position based on the TDC signals.

DTC No.
DTC Detection Condition
Trouble Area
12
No TDC signal to ECM at 400 rpm or more
  1. Open or short in crankshaft position sensor circuit
  2. Crankshaft position sensor
  3. ECM

WIRING DIAGRAM


A119265E01


INSPECTION PROCEDURE

1.INSPECT CRANKSHAFT POSITION SENSOR


    A105091E01
  1. Check the crankshaft position sensor installation.

  1. Disconnect the crankshaft position sensor connector.

  1. Measure the resistance of the crankshaft position sensor.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Cold
    19 to 32 Ω
    1 - 2
    Hot
    24 to 37 Ω

    NOTICE:
    In the chart above, the terms "cold" and "hot" refer to the temperature of the sensor. "Cold" means approximately -10 to 50°C (14 to 122°F). "Hot" means approximately 50 to 100°C (122 to 212°F).



NG
REPLACE CRANKSHAFT POSITION SENSOR
OK


2.CHECK ECM (TDC, NE SIGNAL)


    A106823E05
  1. While cranking or idling, measure the waveform according to the value(s) in the table below.

    OK:
    Tester Connection
    Specified Condition
    E23-17 (TDC+) - E23-16 (TDC-)
    Correct waveform is as shown
    E23-19 (NE+) - E23-18 (NE-)
    Correct waveform is as shown



OK
REPLACE ECM
NG


3.CHECK WIRE HARNESS (ECM - CRANKSHAFT POSITION SENSOR)


    A106824E03
  1. Disconnect the C4 crankshaft position sensor connector.

  1. Disconnect the E23 ECM connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    C4-1 (+) - E23-17 (TDC+)
    Below 1 Ω
    C4-2 (-) - E23-16 (TDC-)
    Below 1 Ω
    E23-17 (TDC+) - E23-16 (TDC-)
    10 kΩ or higher
    E23-17 (TDC+) - Body ground
    10 kΩ or higher
    E23-16 (TDC-) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

CHECK FOR INTERMITTENT PROBLEMS