DTC 42 Vehicle Speed Sensor Signal Circuit Malfunction |

| DTC No. | DTC Detection Condition | Trouble Area |
| 42 | All conditions below are detected continuously for 8 sec. or more:
|
|

| 1.CHECK SPEEDOMETER (OPERATION) |
Drive the vehicle and check if the operation of the speedometer in the combination meter is normal.
|
| ||||
| OK | |
| 2.CHECK ECM (SP1 VOLTAGE) |
![]() |
Move the shift lever to the neutral position.
Jack up the vehicle.
Turn the ignition switch ON.
Measure the voltage between the terminals SP1 and E1 of the ECM connector when the wheel is turned slowly.
| Tester Connection | Specified Condition |
| E20-9 (SP1) - E23-14 (E1) | Correct waveform is as shown |
|
| ||||
| NG | |
| 3.CHECK WIRE HARNESS (COMBINATION METER - ECM) |
![]() |
Disconnect the E20 ECM connector.
Disconnect the C8 combination meter connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| C8-6 - E20-9 (SP1) | Below 1 Ω |
| E20-9 (SP1) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||