ECD SYSTEM > DIAGNOSIS SYSTEM |
| DESCRIPTION |
![]() |
Description for M-OBD
![]() |
| NORMAL MODE AND CHECK MODE |
| 2-TRIP DETECTION LOGIC |
| FREEZE FRAME DATA |
| DLC3 (Data Link Connector 3) |
![]() |
| Symbols (Terminal No.) | Terminal Description | Condition | Specified Condition |
| SIL (7) - SG (5) | Bus "+" line | During transmission | Pulse generation |
| CG (4) - Body ground | Chassis ground | Always | Below 1 Ω |
| SG (5) - Body ground | Signal ground | Always | Below 1 Ω |
| BAT (16) - Body ground | Battery positive | Always | 9 to 14 V |
| BATTERY VOLTAGE |
| MIL (Malfunction Indicator Lamp) |
The MIL illuminates when the ignition switch is ON and the engine is not running.
The MIL should turn off when the engine is started. If the MIL remains illuminated, the diagnosis system has detected a malfunction or abnormality in the system.