ELECTRONIC CONTROLLED AUTOMATIC TRANSMISSION SYSTEM (for 1GR-FE) > DTC CHECK / CLEAR |
| CHECK DTC (USING INTELLIGENT TESTER) |
![]() |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the intelligent tester ON.
![]() |
Enter the following menus: Powertrain / Engine and ECT / DTC.
Check and make a note of DTCs and freeze frame data.
Confirm the details of the DTCs (Click here).
| CLEAR DTCS AND FREEZE FRAME DATA (USING INTELLIGENT TESTER) |
![]() |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON (do not start the engine) and turn the intelligent tester ON.
Enter the following menus: Powertrain / Engine and ECT / DTC / Clear.
Erase DTCs and freeze frame data by pressing YES on the tester.
Turn the ignition switch OFF and then turn it ON again. Check that the monitor is not displaying any DTCs.
| CLEAR DTCS AND FREEZE FRAME DATA (NOT USING INTELLIGENT TESTER) |
![]() |
Perform either one of the following operations.
Disconnect the cable from the negative (-) battery terminal for more than 1 minute.
Remove the EFI and ETCS fuses from the engine room junction block and relay block.