DTC P0711 Transmission Fluid Temperature Sensor "A" Performance |
| DTC Code | DTC Detection Condition | Trouble Area |
| P0711 | Both (a) and (b) are detected (2 trip detection logic). (a) Intake air and engine coolant temperature are higher than -10°C (14°F) at engine start. (b) After normal driving for more than 39 min. and 9 km (6 miles) or more, the No. 1 ATF temperature is less than 20°C (68°F). | Transmission wire (No. 1 ATF temperature sensor) |
| DATA LIST |
Warm up the engine.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / ECT / Data List.
According to the display on the tester, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| A/T Oil Temperature 1 | No. 1 ATF temperature sensor value/ Min.: -40°C (-40°F) Max.: 215°C (419°F) |
| If the value is -40°C (-40°F) or 215°C (419°F), the No. 1 ATF temperature sensor circuit is open or shorted. |
| Temperature Displayed | Malfunction |
| -40°C (-40°F) | Open circuit |
| 150°C (302°F) or higher | Short circuit |
| 1.CHECK DTC OUTPUT (IN ADDITION TO DTC P0711) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / ECT / Trouble Codes.
Read the DTCs using the tester.
| Result | Proceed to |
| Only P0711 is output | A |
| P0711 and other DTCs are output | B |
|
| ||||
| A | |
| 2.CHECK TRANSMISSION FLUID LEVEL |
Check the transmission fluid level.
|
| ||||
| OK | ||
| ||