VANE PUMP (for 5L-E) > DISASSEMBLY |
| 1. REMOVE POWER STEERING SUCTION PORT UNION |
![]() |
Remove the bolt and power steering suction port union.
Using a screwdriver, remove the O-ring from the power steering suction port union.
| 2. REMOVE FLOW CONTROL VALVE |
![]() |
Remove the pressure port union.
Remove the O-ring from the pressure port union.
Remove the flow control valve and compression spring.
| 3. REMOVE REAR VANE PUMP HOUSING |
![]() |
Remove the 4 bolts and rear vane pump housing.
Remove the gasket.
Remove the 2 O-rings from the rear vane pump housing.
| 4. REMOVE REAR VANE PUMP SIDE PLATE |
Remove the wave washer from the rear vane pump side plate.
![]() |
Remove the rear vane pump side plate.
| 5. REMOVE VANE PUMP CAM RING |
![]() |
Remove the vane pump cam ring.
| 6. REMOVE VANE PUMP ROTOR |
Remove the 10 vane pump plates.
![]() |
Using 2 screwdrivers, remove the vane pump shaft snap ring from the vane pump shaft.
Remove the vane pump rotor.
| 7. REMOVE VANE PUMP SHAFT |
| 8. REMOVE PUMP HOUSING OIL SEAL |
![]() |
Using a screwdriver, pry out the vane pump housing oil seal.