Home › ENGINE · 5L-E › ENGINE CONTROL SYSTEM › ECD SYSTEM

ECD SYSTEM > Air Conditioning Signal Circuit

for Preparation Click here


DESCRIPTION

When the A/C compressor is on, the A/C amplifier sends the A/C signal to the ECM, then the ECM increases the fuel injection volume to improve driveability during engine idling.

WIRING DIAGRAM


A119279E01


INSPECTION PROCEDURE


When using intelligent tester:

1.READ VALUE USING INTELLIGENT TESTER (AIR CONDITIONING SIGNAL)
  1. Connect the intelligent tester to the DLC3.

  1. Start the engine.

  1. Turn the A/C switch ON.

  1. Enter the following menus: Powertrain / Engine and ECT / Data List / A/C SIG.

    Result:
    A/C Compressor
    Display
    OFF
    A/C SIG OFF
    ON
    A/C SIG ON



NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE 

2.INSPECT ECM (AC1 VOLTAGE)


    A062416E54
  1. Start the engine.

  1. Measure the voltage of the ECM connector.

    Standard voltage:
    Tester Connection
    Connection
    Specified Condition
    E21-2 (AC1) - Body ground
    A/C compressor ON
    Below 1.5 V
    E21-2 (AC1) - Body ground
    A/C compressor OFF
    7.5 to 14 V



NG
Go to step 3
OK

REPLACE ECM 

3.CHECK WIRE HARNESS (ECM - AIR CONDITIONING AMPLIFIER)


    A062418E09
  1. Disconnect the A9 A/C amplifier connector.

  1. Disconnect the E21 ECM connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    A9-14 (AC1)* - E21-2 (AC1)
    Below 1 Ω
    E21-2 (AC1) - Body ground
    10 kΩ or higher

    HINT:
    *: Terminal arrangement (Click here).



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE AIR CONDITIONING AMPLIFIER 


When not using intelligent tester:

1.INSPECT ECM (AC1 VOLTAGE)


    A062416E55
  1. Start the engine.

  1. Measure the voltage of the ECM connector.

    Standard voltage:
    Tester Connection
    Connection
    Specified Condition
    E21-2 (AC1) - Body ground
    A/C compressor ON
    Below 1.5 V
    E21-2 (AC1) - Body ground
    A/C compressor OFF
    7.5 to 14 V



OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
NG


2.CHECK WIRE HARNESS (ECM - AIR CONDITIONING AMPLIFIER)


    A062418E09
  1. Disconnect the A9 A/C amplifier connector.

  1. Disconnect the E21 ECM connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    A9-4 (AC1)* - E21-2 (AC1)
    Below 1 Ω
    E21-2 (AC1) - Body ground
    10 kΩ or higher

    HINT:
    *: Terminal arrangement (Click here).



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE AIR CONDITIONING AMPLIFIER