DTC C0278/11 Open in ABS Solenoid Relay Circuit |
DTC C0279/12 Short to B+ in ABS Solenoid Relay Circuit |
| DTC Code | DTC Detection Condition | Trouble Area |
| C0278/11 | When either condition below is met:
|
|
| C0279/12 | Immediately after the ignition switch is turned to ON, the solenoid relay contact is closed for 4 seconds when the relay is turned off. |
|
| 1.INSPECT SKID CONTROL ECU (+BS TERMINAL) |
![]() |
Disconnect the skid control ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S35-12 (+BS) - Body ground | Always | 11 to 14 V |
|
| ||||
| OK | |
| 2.INSPECT SKID CONTROL ECU (GND1 AND GND2 TERMINALS) |
Disconnect the skid control ECU connector.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S35-1 (GND1) - Body ground | Always | Below 1 Ω |
| S35-13 (GND2) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 3.RECONFIRM DTC |
Clear the DTC(s) (Click here).
Start the engine.
Drive the vehicle at a speed of 20 km/h (12 mph) or more for 30 seconds or more.
Check if the same DTC is recorded (Click here).
| Result | Proceed to |
| DTC not output | A |
| DTC output | B |
|
| ||||
| A | ||
| ||