DTC C1246/46 Master Cylinder Pressure Sensor Malfunction |
DTC C1281/81 Master Cylinder Pressure Sensor Output Malfunction (Test Mode DTC) |

| DTC Code | DTC Detection Condition | Trouble Area |
| C1246/46 | When one of the following conditions is met:
|
|
| C1281/81 | Detected only during Test Mode. |
|
| 1.CHECK STOP LIGHT OPERATION |
Check that the stop light comes on when the brake pedal is depressed, and goes off when the brake pedal is released.
| Condition | Illumination Condition |
| Brake pedal depressed | ON |
| Brake pedal released | OFF |
|
| ||||
| OK | |
| 2.READ VALUE USING INTELLIGENT TESTER (MASTER CYLINDER SENSOR) |
Connect the intelligent tester to the DLC3.
Start the engine.
Select the Data List mode on the intelligent tester (Click here).
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Master Cylinder Sensor | Master cylinder pressure sensor reading / min.: 0 V, max.: 5 V | When brake pedal is released: 0.3 to 0.9 V | Reading increases when brake pedal is depressed |
Check that the value of the master cylinder pressure sensor observed on the intelligent tester changes when the brake pedal is depressed.
|
| ||||
| OK | |
| 3.READ VALUE USING INTELLIGENT TESTER (STOP LIGHT SW) |
Select the Data List mode on the intelligent tester (Click here).
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Stop Light SW | Stop light switch / ON or OFF | ON: Brake pedal depressed OFF: Brake pedal released | - |
Check that the stop light switch condition observed on the intelligent tester changes when the brake pedal is depressed.
|
| ||||
| OK | |
| 4.RECONFIRM DTC |
Turn the ignition switch off.
Clear the DTC(s) (Click here).
Start the engine.
Drive the vehicle at a vehicle speed of 30 km/h (19 mph) and depress the brake pedal strongly for approximately 3 seconds to perform a braking test (decelerate the vehicle by depressing the brake pedal).
Check if the same DTC is recorded (Click here).
| Result | Proceed to |
| DTC not output | A |
| DTC output | B |
|
| ||||
| A | ||
| ||
| 5.INSPECT SKID CONTROL ECU (STP TERMINAL) |
![]() |
Turn the ignition switch off.
Disconnect the skid control ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| S35-2 (STP) - Body ground | Stop light switch ON (Brake pedal depressed) | 8 to 14 V |
| S35-2 (STP) - Body ground | Stop light switch OFF (Brake pedal released) | Below 1.5 V |
|
| ||||
| OK | ||
| ||