DTC C1267/67 Brake Pedal Load Sensing Switch |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1267/67 | When one of the following conditions is met:
|
|

| 1.READ VALUE USING INTELLIGENT TESTER (STOP LIGHT SWITCH AND BRAKE PEDAL LOAD SENSING SWITCH) |
Connect the intelligent tester to the DLC3.
Select the Data List mode on the intelligent tester (Click here).
| Tester Display | Measurement Item / Range | Normal Condition | Diagnostic Note |
| Stop Light SW | Stop light switch / ON or OFF | ON: Brake pedal depressed OFF: Brake pedal released | - |
| Brake Pedal Load Sensing SW | Brake pedal load sensing switch / ON or OFF | ON: Brake pedal depressed beyond a specified point OFF: Brake pedal not depressed beyond a specified point | - |
Check that the stop light switch display and brake pedal load sensing switch display observed on the intelligent tester change according to brake pedal operation.
Slowly depress the brake pedal, and check the illumination of the stop light switch and brake pedal load sensing switch.
| Result | Proceed to |
| OK | A |
| NG (The brake pedal load sensing switch does not turn on) | B |
| NG (The brake pedal load sensing switch turns on first) | C |
|
| ||||
|
| ||||
| A | |
| 2.RECONFIRM DTC |
Clear the DTC(s) (Click here).
Start the engine.
Perform a road test.
Check if the same DTC is recorded (Click here).
| Result | Proceed to |
| DTC C1267/67 is not output | A |
| DTC C1267/67 is output | B |
|
| ||||
| A | ||
| ||
| 3.INSPECT BRAKE PEDAL LOAD SENSING SWITCH |

Turn the ignition switch off.
Make sure that there is no looseness at the locking part and the connecting part of the connector.
Disconnect the brake pedal load sensing switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 2 - 1 | Brake pedal load sensing switch OFF (Brake pedal depressed) | 950 to 1050 Ω |
| 2 - 1 | Brake pedal load sensing switch ON (Brake pedal released) | 203 to 223 Ω |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - BRAKE PEDAL LOAD SENSING SWITCH) |
![]() |
Turn the ignition switch off.
Make sure that there is no looseness at the locking part and the connecting part of the connector.
Disconnect the skid control ECU connector.
Disconnect the brake pedal load sensing switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S35-27 (FSW+) - B8-2 | Always | Below 1 Ω |
| S35-27 (FSW+) - Body ground | Always | 10 kΩ or higher |
| B8-1 - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||
| 5.CHECK BRAKE PEDAL AND STOP LIGHT SWITCH INSTALLATION |
Turn the ignition switch off.
Check the brake pedal height and stop light switch installation (Click here).
|
| ||||
| OK | ||
| ||